Sport Bikes banner

1 - 5 of 5 Posts

·
Industrial superstar
Joined
·
722 Posts
Discussion Starter #1
Anyone else ever have the connector plug ,coming off your stator and connecting it to the wire harness, melt down? I have had three bikes and it seems like on all of them when I have had the plastics off I noticed the stator plug was all melted and I had to replace it with aftermarket connectors.
 

·
Registered
Joined
·
329 Posts
I just found that my plasitc coupling were melted also. This is on a 01 gsxr 600. In my case my stator is aftermarket.. that might be the cause. Where did you get your aftermarket coupling? Did you just cut the melted stuff, solder, and use eletrical tape to reconnect the two ends?
 

·
Banned
Joined
·
2,093 Posts
Buy a Honda.... bahahaha
 

·
Industrial superstar
Joined
·
722 Posts
Discussion Starter #4
I just used normal commercial grade male/female wire connectors that can be disconnected from eachother. I'm sure radio shack has a three wire, harness type connerctor you could buy too.
 
1 - 5 of 5 Posts
Top