Sport Bikes banner
1 - 3 of 3 Posts

2,680 Posts
Discussion Starter · #1 ·
I want to do some frame welding on my XT550 and I don't know what I should do as far as protecting my electronics. I want to weld a suspension mount for a customized shock so I need a strong clean weld. My father has a stick welder but I can get ahold of just about any welder I would want right down the road.

Getting electronics for this bike is impossible and expensive, ESPECIALLY the CDI unit which I had to source from new Zealand for a few hundred bucks, so primary concern is protection of electronics.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.