Sport Bikes banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
i just bought a new power commander and can not figure out how to set up and load the maps to the commander. I down load the maps from the CD rom and from the internet and cant figure out were they go they are not with the rest of the program it is all brand new and i have everything. The directions Sux. Can someone please help me figure out how to load the maps onto the commander so i can put it on my bike and get riding again.
 

·
Posse Pimp Daddy #1
Joined
·
2,767 Posts
quit being a cheap ass and take the damn thing somewhere to have it mapped properly
 

·
Registered
Joined
·
50 Posts
if you have the pc3usb, here is how you do it:
1. install the software onto your computer
2. plug the usb chord into the pc3 and the other end into your computer
3. plug the 9v battery power supply into your pc3
4. download the map you want
5. go into the pc3usb program and click on "open map file"
6. load the map you downloaded into the program
7. click on "send map"
and you are done. go plug your pc3usb inot your bike and start her up. if you have the pc3r, the instructions are similar, except you need to have a laptop and the pc3r must be installed on the bike and the bike must be on (depending on what bike you have).

good luck!
 
1 - 3 of 3 Posts
Top