Sport Bikes banner
1 - 5 of 5 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
So I took the shield off to clean it and then put it back on. Now it won't close properly. When I use the tab or any part of the shield from the center to the left, the right side will slightly pop out of the locking mechanism. The part that pops out is on the front of the lock and I can push it back on pretty easily and clicks into place. Did a break something somehow? I never used a large amount of force to take it on or off. Anyone else with this problem?
 

·
Registered
Joined
·
74 Posts
It sounds like you just didn't get the face shield back on properly. Mine does that if it's not locked in place, it's an indication to take it off and start over.
 

·
Registered
Joined
·
837 Posts
Pull the face shield off and look closely at both sides where it attaches to the helmet. Compare the side which comes loose with the side which does not. If they are the same we will need to send you a new pivot kit.

If the shield looks ok I need you to send your address for shipping to [email protected] and I will have the shipping dept send out a set to you tomorrow.

Brian Van
 
1 - 5 of 5 Posts
Top