Sport Bikes banner
1 - 6 of 6 Posts

·
Registered
Joined
·
413 Posts
Discussion Starter · #1 ·
I bought my GSXR and it appears to be lowered, the dog bones are stock. What else could have been done to lower the bike? I want it back to stock height.

Thanks,
Brandon
 

·
El A MC Rider
Joined
·
336 Posts
Maybe they compressed the stock spring, put on a shorter spring, or just cut the stock spring to lower it. Did they also cut the kickstand? I ask because my cousin just had her GSXR 600 lowered (with dogbone), but they had to cut a few inches off the kickstand so it would lean properly.
 

·
Registered
Joined
·
413 Posts
Discussion Starter · #3 ·
The kickstand is intact. The spring isn't cut. A friend of mine lowered the spring all of the way and it didn't move a bit. I have talked to quite a few people and so far no one seems to know what has happened to the bike. My next shot, is take it to a shop to have them figure it out, but of course I would rather not.

Thanks,
Brandon
 

·
Registered
Joined
·
2,722 Posts
check the fork tube hieght in the triple trees.
 

·
Registered
Joined
·
413 Posts
Discussion Starter · #5 ·
I think it is right, but I am not 100% sure were it is supposed to be. Between the back tire and the rear fender there isn't much room at all.
 
1 - 6 of 6 Posts
Top