Sport Bikes banner
1 - 1 of 1 Posts

·
Registered
Joined
·
101 Posts
Installing the advancer is really straight forward. You have to locate the timing cover on the lower right hand side of the motor. The cover is held on by 4 bolts and is identified by a couple of wires that run into the crankcase near the cover. Remove that cover, then just remove the one nut holding the ignition rotor to the crank shaft and replace it with your new advancer. When you get the old one off, you'll see an alignment pin on the shaft. Just make sure you line that pin up with the slot on the back side on the new rotor, and put the cover back on. It should take longer to get the lower fairings off then it should to change the ignition rotor. Good luck.

PS - You can go to www.buykawasaki.com and look at the exploded parts diagrams to get a better understanding of how it works.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top