[i_wanna_bike]

I'm installling my fender eliminator and signals on my 600rr and the wire ends aren't the same for the aftermarket and the stock signals. The wire from the bike to the signals doesn't look like it is going to connect to the signal wires correctly. Am I just supposed to take the wires off the bulb casing of teh stock signals and soder the wire ends together.

 

[Rodes]

You Could soder the wire ends together if you want. But if you ever intend to remove the lights it will be a pain in the ass to have to cut, and then resoder. What i did on mine was I went to Radio shack and bought a pair of male and female conectors. Just cut the factory connector off, attatch the Female side to the Bike, and the male side to the light and there yeah go.

 

[i_wanna_bike]

thanks for the tip. appreciate it.