Sport Bikes banner

electrical help asap

368 Views 9 Replies 4 Participants Last post by  toyotapower
ok, i know this isn't supposed to go in general sportbikes but i'd like to get help fast and this probably has the most traffic. i'm hooking up my scorpio alarm right now, the ignition disable feature to be specific. this calls for me to cut the ignition wire and connect their wiring in series. there are obviously a few places i can splice into, i've chose to go right below the fusebox because the wires will reach the control unit and it'd be hard for thieves to get to this. here's my question: which one is the ignition wire. i see the ignition label on the fusebox, and i see all the wires below, my question is which one? the manual says orange with white stripe, i can't really tell, any suggestions? this is obviously something i don't want to fuck up, i'm 99% sure that this is the right one with the circle.


See less See more
1 - 1 of 10 Posts
Dude, just take out the fuse for the ignition and test for continuity from the fuse holder to the connector pin.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.