Sport Bikes banner

1 - 10 of 10 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter #1
Bike not running correctly after ignition advancer install. When i get to 10,000 rpm, the bike just revs and starts to red line without getting much power. I wanted to run the bike hard after I installed it, and something just didnt seem right. Even in second gear when I got to 10,000 rpms, the bike reved fast into redline. Any ideas
 

·
MODERATOR
Joined
·
5,547 Posts
are you sure you got the timing marks correct?
The Factory Pro +4 degree ignition advancer that I have only goes on one way. Sounds as if he has another problem.
 

·
Registered
Joined
·
2 Posts
Bike not running correctly after ignition advancer install. When i get to 10,000 rpm, the bike just revs and starts to red line without getting much power. I wanted to run the bike hard after I installed it, and something just didnt seem right. Even in second gear when I got to 10,000 rpms, the bike reved fast into redline. Any ideas
 
1 - 10 of 10 Posts
Top