Sport Bikes banner
1 - 2 of 2 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
I went over a really bumpy railroad crossing last week going about 45mph. The train tracks crossed the road at about a 45 degree angle. I guess I was in the shit wrong part of the lane, because I ended up with two bent wheels. The lip on the wheel where it meets the tire is bent out about 1/4th - 1/2 of an inch, for maybe 3-4 inches on one side of each wheel. The wheels are not steel, they are some type of alloy. Is it possible to fix this, or do I need new wheels? ($1100 for both from the dealer + installation). Any good aftermarket sources for wheels? I'm not happy.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top