Originally Posted by Dubbington
Here are some pics....I cant pull anymore wires out and dont think I have found the SPLICE you were talking about.
I was talking about the splice in the cover you already found ... Not in the wire itself. The geen with orange stripe wire in the middle of the picture is the one you splice into. I chose to strip about a quarter inch of insulation and T into it there. You don't have to though the wire dead ends in the harness ahead. You can merely cut it in two and add your extra wire to the end running from the handlebar if you want. I figured this way if I want to go back to stock I just cut the wire off tape the splice and retape the factory harness covering and it looks 100% like it did when it left the factory.
I merely chose this location as it didn't require me to cut the harness covering like you do if you go closer to the switch and it allowed me to run all my new wire inside the fairing.
Sorry for any confusion
When in doubt just take a nap its easier.