ZZR/ZX6R flushmounts found.

[ifgshooter]

Finally found a cheaper alternative to Gregg's flushmounts. These appear to be good quality, mount the same as Gregg's, have a larger lens area, and use filament bulbs so you don't need load resistors to stop the hyper flashing associated with LED's. And they fit a wide variety of Kawasaki sportbikes. Check 'em out here http://www.sportbikeeffects.com/prod...rod=334%2D0900

[bigw00dy]

Good find! They even have the option for running lights.

[WSU_bean]

Does anyone know if adaptor plates are needed? And if one were inclined to get the LED's, would an inline resistor be need to make them blink at a normal speed, same with a tail light integrator LED option?

[ifgshooter]

You will need load resistors for the LED version(one for each LED signal). Thats the only downside of the LED's. If you have rear LED's you can get an electronic flasher so you don't need load resistors. You don't need adapter plates because most flushmounts mount from the rear with washers and screws. Go to www.superbrightleds.com for the best price on resistors, electronic flashers and LED bulbs.

[WSU_bean]

thanks, but is the picture in the bottom left, is that of the resistor? and i couldn't find it on the link.

[ifgshooter]

Yea thats it. Check this link hopefully this helps. http://www.superbrightleds.com/tail-brake-turn.html