Looking for Frame Sliders

[7r-iddy]

Can anyone recommend some frame sliders to me? I've heard that the fairings need to be cut/altered also. how difficult of a job is this? thanks!

[KMW ZX7R]

Its simple just use a laser pointer to center the hole saw with the frame bolt.
1. Take the fairing off
2. Set the bike level with the ground stands would do the job
3. Set up the laser pointer so it points to the center of the frame bolt
4. But the fairing back on but dont move the bike or the laser pointer
5. u will see the laser on the fairing in thesame spot the frame bolt is mark that spot with a marker
6. get a hole saw 2" or 2 1/8" will do and drill/cut the fairing where u marked the spot on the fairing
7. Do the same for the other side 1-6

[7r-iddy]

Thanks a lot!! I'll definately be picking some up and trying it myself.

[KMW ZX7R]

No problem
Get some good ones they will save ur plastics, i have the LP Carbon Ones havent tested them yet thank god

[highside7r]

They will, I have the LP Ricochet, went down lowside in Jan. due to sand. The only problem was I went down on the right, so my Akra can was toasted. With these you can just replace the slider end, not the whole thing.