Zx12

[b ralston]

Where are all the Kawi boys on this forum? Havn't been on here in a while.......

[biggmo]

Just got on and looking for a map for a 2000 zx12, pc3usb,full tit muzzy exhaust, k&n filter, 1270 piston kit, adjustable cam sprocket assembly

[biggmo]

i m new to this. i still havent got any answers back

[ZXLNT]

Your set up sounds pretty close to mine, whats your email???

[biggmo]

biggmo@aol.com Ended up with 171hp 96 ft torque with a 240 wide tire kit. clutch slips in high rpms. Went with 3 heavier springs, still same problem. Going to try with all heavier. Hopefully it works, and I may see higher numbers

[biggmo]

i also used a map I found from cliff randalls zx12r, the only difference I saw with his setup was a high performance fuel pump. I don't think that matters to the map. Like I said I don't think!!! Still going to be limited to the injectors

[ZXLNT]

Thats somewhat low for a 1270 motor. But I imagine all that extra tire and wheel are robbing some power. My 1270 makes 182HP and 101 for torque...

[biggmo]

What did urs have to start out. Mine had 152 and 83. I was actually looking for those type numbers u had. I hope its because of the clutch slipping and not giving the exact numbers. What type of clutch setup do u have. I put schnitz heavy springs (6). Clutch is hard as hell to pull. Just did it tonight now its raining so I will see if it works. Clutch shouldn't be like that just to stop the slippage. Someone said something about the type oil could b the problem. my email address is biggmo@aol.com.

[ZXLNT]

153.2 HP and 89 for torque stock.

[biggmo]

did u do any head work, and again what clutch and kind of oil do you run

[ZXLNT]

Muzzy clutch hub and kit, Falicon billet basket, Motul Semi synthetic, and just a very minor port clean up.

[soxxerms]

zx10r here in mississippi

[biggmo]

Do you have your map on your computer, I would like to compare. If not, thanks for ur help with everything, u have been a big help (as long as it works)haha