fuel mapping question

[MrSilver]

I just had micron pipes and PC3usb put on my '01 RC51. I haven't been able to find a map specifically for the microns. Does anyone have any info on which maps would work best with them? The bike seems to run fine, noticebly stronger than before, I just want to get the most out of the mods.

Thanks.

[V V V]

http://www.powercommander.com/105-111.shtml

[MrSilver]

I've been to this page (and downloaded the maps), but my question is which one to use with the microns. There are specific maps for various exhausts, but microns are not on the list. Does anyone know which will work best with them?

[V V V]

Originally Posted by MrSilver

I've been to this page (and downloaded the maps), but my question is which one to use with the microns. There are specific maps for various exhausts, but microns are not on the list. Does anyone know which will work best with them?

You're right and wrong. They do have micron slip-on's for the SP1 but using PC2.

http://www.powercommander.com/105_pciimaps.shtml

[V V V]

Originally Posted by V V V

You're right and wrong. They do have micron slip-on's for the SP1 but using PC2.

http://www.powercommander.com/105_pciimaps.shtml

I'd say until you find someone with the specific map, I would try the map for the sato pipes. I've heard people having great success with it even if you have different pipe than sato's. Good luck!

[MrSilver]

Thanks VVV. I understand that maps for the pc2 and pc3 are not interchangeable; part of my problem. I'll give the Sato map a try.

I appreciate the help,man.

Take care.

[plum]

I had a similar problem when mapping my Arrow 2 into 1. I used the Jarden map and it ran good but after a couple hours on the dyno to dial it in it ran much better.

If there is a dyno in your area I would throw it on there if you can.

[3_Down]

try rc51.org, and Dan Kyle at kyleusa.com...those resourceswill get you the right answers!