Just completed my SET Valve disconnect.

kazlab67 · 03-03-2007, 11:06 AM

Well I followed the SET Valve disconnect instructions and only took a few minutes. Will now go ride it and let you know if I feel a difference.

SET Valve Mod Question K6-K7-K8 600/750 (Updated w/K5-K6 1k info)

jk750 · 03-03-2007, 02:41 PM

Let us know!

kazlab67 · 03-03-2007, 04:16 PM

OK so I rode around earlier for about an hour.

The MOD is worth doing. I had absolutely no choppiness on the throtle at low RPM's in first or second. Some days, there is almost an on/off moment on the throttle while cruising through the neighborhood slowly. That seems to have disappeared.
Also when cranking it in second, the front started coming up which I haven't been able to do before.

I did try to yank Pin 30 but had no luck so I ended up cutting it and wrapping the ends in electric tape.

jk750 · 03-03-2007, 05:14 PM

Good job! Thanks for the write-up!

OFFICER737 · 03-03-2007, 06:43 PM

Ahhh...this will be my next mod

Plus it's a freebie

Kaz, thanks for letting us know how the new GSXR does with it

kazlab67 · 03-04-2007, 10:37 AM

No problem guys.
I will ride it more today and see if there are any losses like in midrange or something. So far I have not felt any ill effects and if there are no issues I will eventually remove the 5lbs of cabling and motor/connectors.
I have read nothing but good things about this Mod and someone even Dynoed the results with no losses shown. I can feel a much smoother first gear response and that is what I was looking for. DO IT!!!!!