New Blinkers

DarkTint · 12-28-2004, 08:49 PM

I am looking to get a set of aftermarket blinkers for my 599. Does anyone have any suggestions or links to a set of good ones? I've never installed a new set of blinkers on a bike, so any info will be helpful.

Thanks!

5hundred99 · 12-29-2004, 06:05 AM

When I ordered my clear tail light lens on eBay, I saw in the picture, the bike also had clear signal lenses. This is the seller if you want to contact him to see if he sells them:

http://feedback.ebay.com/ebaymotors/...536177&frm=284

That's about all I've seen aside from the smaller universal ones you can get from LP and the like.

Ba55man · 06-28-2005, 02:25 PM

I've just fitted these........

I got them from Jesters trick bits, I'll post the addy if its any use to you.

DarkTint · 10-06-2005, 04:48 PM

Very nice. When you installed them, did you have to do anything special, or was it as easy as unplugging the stock blinkers, and plugging in the new ones and finding mounting points?

Ba55man · 10-08-2005, 02:47 PM

It was just a case of unplug and plug the new ones back in, I got them from Jesters Trick Bits.
Check them out here........... http://www.jesterstrickbits.co.uk/acatalog/

DarkTint · 10-11-2005, 02:11 PM

Jesters has some pretty cool stuff. I wish they had the fender eliminator kit for the 04 Hornet.

I think I found the blinker set-up I want (at least for the rear): http://www.stockmildtowild.com/Merch...TED-TAILLIGHTS

I've seen these integrated blinkers in person and they look fantastic. If I got this I could chop off pretty much the entire rear license plate bracket (including the light for the license plate) and mount the plate directly under the tail light. The only thing that could cause me a problem is the lock assembly for the seat. It looks as though it's cable operated and could be re-located. Do you know anyone who has tried to move it?

Ba55man · 10-11-2005, 06:58 PM

If Im not mistaken its just a case of undoing the lock and moving it either to a hole you have drilled for it or a pre drilled hole on something like an undertray, I have a fender eliminator its off a 02 model I dont think the front fender on the '04 is any different to the '03 or '02 for that matter, Just been reading a thread by Jester and he has a supplier on your side of the water......

My US supplier is David Cork

try.. www.streetfightersbydesign.com

Check them out you never know.