Sportbikes.net - View Single Post

Ranast · 08-03-2007, 08:20 PM

After getting my power commander installed, I was trying out the faceplate buttons.

I depressed the three faceplate buttons to enter button mode (per the instructions) and nothing happened. The first time I tried this, the bike was turned off and the 9 volt battery was hooked up. The power commander came to life but the LED stayed at the bottom.

So I fired up the bike and same thing.

Both times I held the buttons down for different lengths of time (5 seconds then 10) and then attempted to click each of them a few times, but the LED stays on the bottom.

I thought you could adjust the PC without a computer?

Or else I permanently locked in super lean?

The PC did fluctuate when the bike was fired up when I touched the throttle but other than that it stayed put.

And yes I did make sure all three buttons were held down simultaneously when attempting to enter button mode. If it is a safety feature to make sure the buttons don't accidentally get bumped when you are just riding around that is fine. Just want to know.

08-03-2007, 08:20 PM	#1 (permalink)
Ranast Comfortably Numb Join Date: Sep 2006 Location: Northern California Age: 39 Posts: 127 Casino Cash: $2873 Sportbike: 93-CBR900RR/07-ZX14	Power commander faceplate buttons After getting my power commander installed, I was trying out the faceplate buttons. I depressed the three faceplate buttons to enter button mode (per the instructions) and nothing happened. The first time I tried this, the bike was turned off and the 9 volt battery was hooked up. The power commander came to life but the LED stayed at the bottom. So I fired up the bike and same thing. Both times I held the buttons down for different lengths of time (5 seconds then 10) and then attempted to click each of them a few times, but the LED stays on the bottom. I thought you could adjust the PC without a computer? Or else I permanently locked in super lean? The PC did fluctuate when the bike was fired up when I touched the throttle but other than that it stayed put. And yes I did make sure all three buttons were held down simultaneously when attempting to enter button mode. If it is a safety feature to make sure the buttons don't accidentally get bumped when you are just riding around that is fine. Just want to know.